Toolhead crashing

Sadly, all kinds of toolhead crashes are quite common

Bed is rising up, doesn't stop and crashes into nozzle

Solution:

Turn off printer from power switch in the back. Wait ~10 sec, move toolhead to center of printer, if bed is really close to nozzle, move it down some cm by manually turning one of the leadscrews on the side of bed. Turn printer back on. On touchscreen tap on cogwheel and then "home". It's important to do it thro printer built-in touchscreen

image.png
(Img base from https://3dprintbeginner.com/qidi-x-max-3-review/)

Possible causes:

Toolhead crashes into the wall of printer

Solution:

Exactly the same as with bed crashes. Check above

Possible causes:

- Printer keeps track of toolhead position all the time. When it's moved by force / accidentally or while printer is off. It won't know it's new location, which might cause collisions


Revision #1
Created 20 November 2023 23:39:44 by McSneaky
Updated 21 November 2023 00:10:42 by McSneaky